aCTIVaTIon
EN
DiBO 23
activation
SET TO WORK
Turn the key contact to position 1 (=on) and wait till the lamp of preheating is
extinguished, then turn the key contact further to position 2 (=STaRT) to start
the fuel engine. leave the key when the fuel engine is started. The automatic
speed control option has a fixed setting on 50 % (or place the throttle lever at
position 1/2, depending the selected option). When the fuel engine is running,
allow the engine to warm up at stationary revolutions. point the spray gun in to
the open space and operate the spray gun until the water supply is completely
de aerated. operate the spray gun and adjust if necessary the spray pressure
by operating the throttle lever/control stick.For the use of hot water, set the
temperature on desired value through the control stick and by following the
instructions of the temperature menu on the display.
after turning 30 minutes into bypass, the cleaner will switch off and an
indictaion will be visualized on the display.
Make sure that the valve is on ‘high temperature function’ and the throttle
is on position ‘high temperature function’, when you want to work with high
temperatures (standard configuration)! use the appropriate spray equipment!
CONTROL COMPONENTS
See chapter:
“Visual perception” on page 16 .
1 KEY SWITCH
The main switch is a key switch and is equipped with three positions:
• on: The JMB will be switched on electrically without however starting the
engine. after switching on, all sensors will be tested automatically and the
glowing process of the engine starts.
• STaRT: as soon as the indication “preheating” is gone, the engine can be
started.
• STop: By turning the key back to the left the engine will be switched off again.
2 CONTROL STICK
The control stick is a switching element with four possible switching positions
(left/right/above/below) and a zero position (middle). This coordinate switch is
suitable for simple navigation in the 4 selectable directions.
3 DISPLAY
on the display you receive possible disturbances and the operating instructions
will be displayed if desired. you also receive a message when service is
necessary / desired, receive status info of the cleaner and check working
hours of the machine. other operating possibilities will be displayed by means
of operating the control stick. The functioning of the control panel will be
described further in this chapter.
4 EMERGENCY STOP
The emergency stop can be recognized on the red pressing button at a yellow
slice.
• push the emergency stop: the machine stops immediately at emergency
situations.
• pull out the emergency stop: the machine can be restarted.
The display screen will be disappeared (powered off) when the emergency stop
is pushed.
5 FUSES
The electrical part off the JMB is protected by different fuses. These fuses are
mounted in the electric box which is mounted against the burner. The fuse for
the sparking plug is mounted on the left side and is accessible by opening the
cover.
