Fine tuning the CX Video Gateway configurationDialogic® Vision™ CX Video Gateway Administration Manual
Route settings
Use the Route keyword to specify information for each route. The following table
describes the parameters for the Route keyword that you can change if the defaults
do not describe your configuration:
Parameter
Description
route_num
Route identifier.
Valid values: 1 - 16
circuit_list
Coma-separated list of BICC circuits or BICC circuit range. To define a circuit
range, specify the first circuit and the last circuit of the range separated by a dash.
The delimiters are included in the route.
The
circuit_list
and
trunk_num
parameters are mutually exclusive.
The following example adds circuits 1, 3, and 10 to 30 into route 2.
Route 2 1,3,10-30
trunk_num
One or more logical trunk identifiers for each trunk in the route. The trunk
identifiers refer to trunks previously declared with the Trunk keyword.
Valid values: 0 - 15
The
circuit_list
and
trunk_num
parameters are mutually exclusive.
select_strategy
(Optional) Defines the route circuits reserved for outgoing calls, and specifies how
the circuits are selected.
Valid values:
•
FROM
_
TOP (default)
•
FROM
_
BOTTOM
•
DESCENDING
•
ASCENDING
•
TIMER
For more information, see
Values for the PSTN routes group
on page 45.
Routing strategies are not supported for BICC IP bound circuits.
The following
telecom.conf
file example shows how to configure two routes on four
ISDN trunks. One route contains trunk 2 with circuit selection strategy DESCENDING.
The other route contains the three remaining trunks with the default circuit selection
strategy (FROM
_
TOP).
# Four trunks (e.g. on a CG board with four E1s)
Trunk 1 1 2 0 E1 TE
Trunk 2 1 2 1 E1 TE
Trunk 3 1 2 2 E1 TE
Trunk 4 1 2 3 E1 TE
# Route 1 contains trunk 2 - selection strategy = DESCENDING
Route 1 2 DESCENDING
# Route 2 contains trunks 1, 3 and 4 - default selection strategy
Route 2 1 3 4
118
Dialogic
