Pag. 34 of 52
11.47
M47 - Protection password programming
In this menu it’s possible to set a password to protect the system from
tampering or other. To store a new password and protect the system proceed
as follows:
press
Change the digit with
and move the cursor to the right with
, max.
value: 99999
press
to store the new password and protect the system by blocking
the changes to the programming
To unlock the changes to the programming, proceed as follows::
press
Enter the previously stored password, modifying the digit with
and moving
the cursor to the right with
.
Press
to confirm and unlock the programming changes.
- Programming menu
11.48 M48 - Calibration data programming
Only for headquarters use.
11.49 M49 - MODBUS serial port test
Only for headquarters use
11.50 M50 - Data logger programming
In this menu it’s possible to enable the data logger with via MODBUS data
transmission. To enable the data logger, proceed as follows:
press
Select “
ON
” with
and press
.
Pressing
is possible to select which data to include in the data logger.
To enable the data storage press
, select “
ON
” and confirm with
See the table below for the available data
0
Date and Time
4
Flow Rate
8
NEG Totalizer
1
System Status
5
Velocity
9
Energy Flow Rate
2
Current Windows
6
NET Totalizer
10
Energy NET Totalizer
3
Signal Strength
7
POS Totalizer
11
Energy POS Totalizer
