8555-M512-O1 Rev E
y
MedVue MV1 Owner’s
32
IMPORTANT! The Hold Mode of operation can only be used in
non-commercial applications and must be disabled (
HOLd MOdE = 0
)
for "Legal for Trade" operations.
CALIBRATION SETUP, CONT.
LOCK
With
LOCK
displayed, press the
ENTER
key. The display will change to
HOLd MOdE
. Proceed to
the
HOLd MOdE
(Hold Mode) parameter.
Otherwise, press the
ID/HEIGHT
key to advance to the
SYSTEM
menu.
HOLd MOdE
(Hold Mode)
The Hold Mode Sets the locking functionality of the MV1.
The display will show
HOLd MOdE
and the current setting. If the value displayed is
acceptable, press the
ENTER
key to save it. Otherwise use the numeric keys to enter a new
value, and then press the
ENTER
key to save it.
Allowable values are 0, 1, or 2.
0 = Hold Mode Disabled
1 = Hold Mode Enabled. Display locked by the
LOCK/RELEASE
key only
2 = Hold Mode Enabled. Display locked by the
LOCK/RELEASE
key and Auto-Lock
x
If
HOLd MOdE = 0
or
1
is selected, proceed to the
LANGUAGE
prompt.
x
If
HOLd MOdE = 2
is selected, an additional prompt
HOLd bANd
will be displayed. Proceed
to
HOLd bANd
(Auto Lock Reset Band) to continue setup.
With the Hold Mode enabled (
HOLd MOdE = 1
), the MV1 will lock the weight shown on the
display when the
LOCK/RELEASE
key is pressed, and unlock the weight display when you
press the key again.
If (
HOLd MOdE = 2
) is selected, the MV1 will lock the weight shown on the display when the
LOCK/RELEASE
key is pressed, and unlock the weight display when you press the key
again, as well as automatically lock the weight shown on the display after obtaining a stable
weight. Note that the stable weight must exceed the
HOLd bANd
(Auto Lock Reset Band)
value. Refer to the next prompt
HOLd bANd
(Auto Lock Reset Band).
HOLd bANd
(Auto Lock Reset Band –
Only if
HOLd MOdE = 2
)
`
If (
HOLd MOdE = 2
) is selected, the display will change to show
HOLd bANd
. This is the
number of division changes needed to reset the Auto Lock. For the Auto Lock to function,
the load on the scale must rise above the
HOLd bANd
value (and remain stable). To release
the Auto Lock, the load on the scale must fall below
HOLd bANd
value. At that point the next
weighing operation can begin.
The display will show
HOLd bANd
and the current setting. If the value displayed is
acceptable, press the
ENTER
key to save it. Otherwise use the numeric keys to enter a new
value, and then press the
ENTER
key to save it.
Allowable values are 0 through 99.
Содержание MedVue MV1
