DentalEZ Core, Руководство пользователя, Страница: 23 / 57

www.DentalEZ.com 866-DTE-INFO
20
CORE
TM
Magellan Unit
PN: 2717-267C
Magellan Unit Post (Continued)
Section III Installation
8. Make sure the pivot pin slot faces the side of
the unit support having the tapped hole.
9. Seat the pivot mount until its head is in full
contact with the bottom and sides of the
Magellan unit support.
10. Use 3/8-16" × 2-1/4" hex head screw,
lockwasher and fl at washer to secure post
pivot pin to unit support.
11. Locate the 1/4-20 × 3/4" long set screw in the
threaded hole on the Magellan unit support.
Then tighten the set screw to prevent the
pivot pin from rotating.
12. Place a 1/4-20 × 3/8" long set screw into
the threaded hole in the fl at member of the
Magellan unit post.
13. Engage the 1/4-20 × 3/8" set screw with a 1/8"
hex key to deform the internal bushing against
the pivot mount until a 3-lb force is required to
rotate the unit post.
14. Install the pivot cover over the bolt head.
Delivery Head
Tools Required
• 5/64" Hex Key
1. Remove the packaging from the delivery
head along with the adjustable arm and the
umbilical assembly.
2. Feed the umbilical assembly into the unit post,
ensuring that the leading end of the
umbilical assembly (with the protective spiral
end) does not catch on the open access slot
or weld seam of the unit post’s fl at joint.
3. After the umbilical assembly is completely
installed in the unit post, insert fl ex arm into
unit post.
4. Secure the bearing arm support with a set
screw using 5/64" hex key.
5. Match and connect the tubes and wires
from the Magellan arm umbilical assembly
to the tubes and wires of the chair umbilical
assembly. Refer to tubing diagram (PN: 2662-
304).
6. For touchpad control equipped, route harness
through chair, connect terminal to main
control board, and coil excess harness.
Delivery
Head