DentalEZ Core, Руководство пользователя, Страница: 22 / 57

19
www.DentalEZ.com 866-DTE-INFO
19
DentalEZ
®
Equipment
PN: 2717-267C
Section III Installation
Magellan Unit Post
Tools Required
• 1/8" Hex Key
1. Select the following hardware package items
(Figure 19) :
• 1/4" x 3/4" Set Screw
• 1/4" x 3/8" Set Screw
• 3/8-16" × 2-14" Hex Head Screw
• 3/8" Flat Washer
• 3/8" Lock Washer
• Four Thrust Washers
• Two Thrust Bearings
• Pivot Cover
• Post Pivot Pin
• Post Stop
2. Place a thrust washer on the bearing surface
of the post pivot pin.
3. Apply lubricant to a thrust bearing and install the
bearing, followed by a second thrust washer.
4. Insert post pivot pin and bearing stack into
unit pole.
5. Position a thrust washer onto the fl at member
of the Magellan unit pole and post pivot pin.
6. Apply lubricant to the second thrust bearing
and install followed by a thrust washer.
7. Insert the post pivot pin and unit pole with thrust
bearing and washers into the unit support.
NOTE: Engagement is a slip fi t, provided the
Magellan unit post is held in alignment.
To avoid damage to the pivot bushing, do not
use force when installing the pivot pin into the
Magellan unit post.
CAUTION
Pivot Cover
Figure 19. Magellan unit post hardware
Pivot Cover
3/8" Hex-head Bolt
3/8" Lock Washer
3/8" Flat Washer
Post Pivot Pin
Slot
Thrust Washers
Unit Pole
1/4-20 × 3.8"
Set Screw
Thrust Bearing
Unit Support
Post Stop
(Ground Point)
1/4-20 × 3.8"
Set Screw
Magellan Unit Post