Dell 540 - USB Photo Printer 540, Руководство пользователя

Страница: 278 / 354

278
Troubleshooting
PROGRAM — Enter the system setup program and correct the date or time (see
"Entering the System Setup Program " on page 308). If the problem persists, replace the
CMOS battery.
T IME - OF - DAY NOT SET – PLEASE RUN THE SYSTEM SETUP PROGRAM — Enter the
system setup program and correct the date or time (see "Entering the System Setup
Program " on page 308). If the problem persists, replace the CMOS battery.
T IMER CHIP COUNTER 2 FAILED — Run the Dell Diagnostics (see "Running the Dell
Diagnostics" on page 281).
T HE A C POWER ADAPTER TYPE CANNOT BE DETERMINED . THE SYSTEM CAN ONLY
BOOT WITH A 1 3 0 - W POWER ADAPTER OR GREATER . STRIKE THE F 1 KEY TO
SHUTDOWN . — Connect a 130-W or greater AC adapter to the computer or docking
station.
NOTE:
This message concerning the requirement of an AC power adapter type of
130-W or greater applies to laptop computers that require a 130-W or greater AC
adapter.
T
HE
A C
POWER ADAPTER WATTAGE AND TYPE CANNOT BE DETERMINED
.
THE
BATTERY MAY NOT CHARGE . THEY SYSTEM WILL ADJUST THE PERFORMANCE TO
MATCH THE POWER AVAILABLE . PLEASE CONNECT A DELL XXX - W A C ADAPTER OR
GREATER FOR BEST SYSTEM PERFORMANCE . STRIKE THE F 3 KEY ( BEFORE THE F 1 OR
F 2 KEY ) IF YOU DO NOT WANT TO SEE POWER WARNING MESSAGES AGAIN . STRIKE
THE F 1 KEY TO CONTINUE , F 2 TO RUN THE SETUP UTILITY . — Connect the correct
AC adapter to the computer or docking station.
T HE COMPUTER IS DOCKED AND ONLY BATTERY POWER IS DETECTED . THIS CAN
HAPPEN IF THE POWER ADAPTER IS MISSING , THE POWER CORD IS UNPLUGGED , OR
THE COMPUTER IS NOT PROPERLY CONNECTED TO THE DOCKING STATION . YOU
SHOULD UNDOCK , REDOCK , ATTACH THE POWER ADAPTER , OR PLUG IN THE POWER
CORD . STRIKE THE F 1 KEY TO SHUTDOWN .
T HE AMOUNT OF SYSTEM MEMORY HAS CHAN GED . IF YOU DID NOT CHANGE YOUR
MEMORY . . . TO RESOLVE THIS ISSUE , TRY TO RESEAT THE MEMORY . STRIKE THE F 1
KEY TO CONTINUE , F 2 TO RUN THE SETUP UTILITY . PRESS F 5 TO RUN ONBOARD
DIAGNOSTICS . —
• Reseat the memory (for instructions, see your computer’s
Service Manual
).
• If memory was not removed or installed, memory module or system board failure
may have occurred. Contact Dell for assistance (see "Contacting Dell" on page 337).
U NSUPPORTED MEMORY . STRIKE THE F 1 KEY TO SHUTDOWN . — Ensure that the
memory you are using is supported by your computer (see the documentation shipped
with your computer).
WA R N I N G : A XXX - W A C ADAPTER HAS BEEN DETECTED , WHICH IS LESS THAN