Dell EMC PowerProtect X400, Руководство по конфигурации и установке оборудования

Страница: 59 / 76

X400 capacity cube serial number
On each X400 capacity cube, locate the serial number on the blue label on the
information tag (luggage tag) pull out tab, and write it down. The information tag pull
out tab is located in the front of the X400 capacity cube under slot 11. For a photo of
the X400 capacity cube serial number on the X400 capacity cube information tag, see
Figure 16 on page 27.
mDNS information
l
The initial login to the PowerProtect X400 Appliance Configuration UI requires the
multicast DNS (mDNS) protocol. The laptop you use for the initial login to the UI
must have mDNS installed on it and it must be connected to an available switch
port that is in the same L2 network of the external network. The software required
to install mDNS on the laptop is:
n
Windows: Apple Bonjour Services https://support.apple.com/kb/DL999
n
Linux: Avahi
n
MacOS/iOS: no additional software required
For instructions on how to install Bonjour on your laptop, see Install mDNS on the
laptop used for the initial login to the PowerProtect X400 Appliance Configuration UI
on page 63.
Internal network information
You must collect information for the internal (private) X400 Appliance network, which
is the dedicated subnet separate from the external/customer network used for data
and management traffic. The high-level internal network requirements are listed in the
following table.
Table 7 Internal network requirements
Platform cube with
one capacity cube Platform cube with
two capacity cubes Platform cube with
three capacity cubes Platform cube with
four capacity cubes
GbE ports 10 12 14 16
GbE network
cables 10 12 14 16
IP prefix A.B.C.0/24 A.B.C.0/24 A.B.C.0/24 A.B.C.0/24
You will need the following information to enter into the PowerProtect X400 Appliance
Configuration UI fields:
l
IP Prefix - for example, 192.168.32.0/24. In the UI, you must enter the IP prefix
(192.168.32 in this example), and the 0/24 is a fixed range. Note that you do not
have to enter these IP addresses in DNS.
l
VLAN ID - VLAN tagging is used to break out a network into separate logical
networks. If the switch port is using untagged/access mode, use VLAN 0. If the
switch port is using tagged/trunk mode, provide the correct VLAN ID that
corresponds to your network.
Pre-configuration tasks
PowerProtect X400 Appliance Hardware Configuration and Installation Guide 59