Dell EMC PowerEdge R7425, Инструкция по установке и обслуживанию

Страница: 141 / 193

3 Using a Phillips #2 screwdriver, tighten the screw to secure the riser to the system.
Figure 98. Installing the expansion card riser 3
Next steps
1 If removed, install the expansion cards into the riser .
2 Connect the cables to the riser.
3 Install the air shroud .
4 If applicable, open the PCIe card holder latch on the air shroud to install the full-length PCIe card.
5 Follow the procedure listed in After working inside your system .
6 Install any device drivers required for the card as described in the documentation for the card.
Optional IDSDM or vFlash module
The IDSDM or vFlash module combines the IDSDM and/or vFlash features into a single module.
NOTE: The write-protect switch is on the IDSDM or vFlash module.
Removing the MicroSD card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
Steps
1 Locate the MicroSD card slot on the IDSDM or vFlash module, and press the card to partially release it from the slot.
2 Hold the MicroSD card and remove it from the slot.
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Installing and removing system components 141