Dell EMC PowerEdge R7425, Инструкция по установке и обслуживанию

Страница: 142 / 193

Next steps
1 Follow the procedure listed in After working inside your system .
2 Install the MicroSD card .
Installing the MicroSD card
Prerequisites
Follow the safety guidelines listed in Safety instructions .
NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the
cards during removal.
Steps
1 Locate the MicroSD card connector on the IDSDM or vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE: The slot is keyed to ensure correct insertion of the card.
2 Press the card into the card slot to lock it into place.
Next step
Follow the procedure listed in After working inside your system .
Removing the IDSDM or vFlash module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
3 For systems that support rear 2.5 inch or 3.5 inch drive configuration, remove the rear drive cage to access the IDSDM or vFlash
module.
4 Remove the expansion card installed in slot 6 or 8, to access the IDSDM or vFlash module.
5 If you are replacing the IDSDM or vFlash module, remove the MicroSD cards .
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Steps
1 Locate the IDSDM or vFlash connector on the system board.
To locate IDSDM or vFlash connector, see the
System board jumpers and connectors section.
2 Holding the pull tab, lift the IDSDM or vFlash module out of the system.
NOTE: There are two dip switches on the IDSDM or vFlash module for write-protection.
142 Installing and removing system components