Dell EMC PowerEdge R7425, Инструкция по установке и обслуживанию

Страница: 137 / 193

Figure 92. Installing the expansion card riser 1
Next steps
1 If removed, install the expansion cards into the riser .
2 Connect the cables to the riser.
3 Follow the procedure listed in After working inside your system .
4 Install any device drivers required for the card as described in the documentation for the card.
Removing the expansion card riser 2
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
3 If applicable, close the PCIe card holder latch on the air shroud to release the full-length PCIe card.
4 Remove the air shroud .
5 If installed, remove the expansion cards installed on the riser .
6 Disconnect any cables connected to the riser.
Steps
1 To remove expansion card riser 2A or 2E:
a Using a Phillips #2 screwdriver, loosen the screws that secure the riser to the system.
b Press the release tab, and holding the riser by its edges, lift the riser from the riser connector on the system board.
Installing and removing system components 137