Introduction
If there is no response, the device will reset to the initial state, and attempt to reconnect.
Also, if the RS-232 link is broken, it will be reconnected automatically if possible (when in Hardware-
connect mode).
This operation is described in the Appendix.
Protocol Conversion
The RS-232 device at the client end and the device at the server end of a link do not have to use the same
communications protocols on the RS232 link (speed, parity, flow control). The EtherPaths will convert the
data to the correct protocol.
Configuration Security
Etherpath configuration may be “Locked-down” or restricted in several ways. The web Browser interface,
telnet configuration interface, and SNMP configuration interfaces may be disabled. Specific IP addresses
may be configured into the unit to disallow configuration from any other than the desired management
workstations.
Upgradeable Firmware
Firmware upgrades are downloadable to the EtherPath. The utility program required for this, and the actual
firmware upgrades, are available from your dealer.
On-board Tools
The Etherpath-X4 contains diagnostic tools such as traceroute, ping, and a simple packet sniffer to aid in
network troubleshooting.
3
