
Installation and maintenance guide
OUTPUT Socket
RDY: Indicates the status when control
operation is enabled.
BUSY: Indicates the status when control
operation is in progress.
END: Indicates the end of a control
operation.
ERR: This signal is indicated when an DA
1000V Controller alarm signal occurs.
GND: Set to COMMON to match the DC
potential difference between the host
controller and the DA 1000V Controller.
INPUT Socket
SHOT: Connected when using the dispense
signal from the host controller.
SEL: Used to select the mode from the host
controller.
> Not currently used.
EMG: Used to stop the DA 1000V Controller
from the host controller.
GND: Set to COMMON to match the DC poten-
tial difference between the host controller and
the DA 1000V Controller.
NANO PENNANOPEN Operation Manual
Doc. Rev 0
2019/7/2
17/47
Copyright © 2019 by TAEHA CORP. All Rights Reserved
<OUTPUT Socket>
OUTPUT
RD
Y
BUS
Y
EN
D
ERR
GN
D
OUTPUT Socket
RDY:
Indicates the status when control operation
is enabled.
BUSY:
Indicates the status when control operation
is in progress.
END:
Indicates the end of a control operation.
ERR:
This signal is indicated when an NPC-10
alarm signal occurs.
GND:
Set to COMMON to match the DC potential
difference between the host controller and the NPC-
10.
<INPUT Socket>
INPUT
SH
OT
SEL
EM
G
GN
D
INPUT Socket
SHOT:
Connected when using the dispense signal
from the host controller.
SEL:
Used to select the mode from the host
controller.
→ Not currently used.
EMG:
Used to stop the NPC-10 from the host
controller.
GND:
Set to COMMON to match the DC potential
difference between the host controller and the NPC-
10.
NANO PENNANOPEN Operation Manual
Doc. Rev 0
2019/7/2
17/47
Copyright © 2019 by TAEHA CORP. All Rights Reserved
<OUTPUT Socket>
OUTPUT
RD
Y
BUS
Y
EN
D
ERR
GN
D
OUTPUT Socket
RDY:
Indicates the status when control operation
is enabled.
BUSY:
Indicates the status when control operation
is in progress.
END:
Indicates the end of a control operation.
ERR:
This signal is indicated when an NPC-10
alarm signal occurs.
GND:
Set to COMMON to match the DC potential
difference between the host controller and the NPC-
10.
<INPUT Socket>
INPUT
SH
OT
SEL
EM
G
GN
D
INPUT Socket
SHOT:
Connected when using the dispense signal
from the host controller.
SEL:
Used to select the mode from the host
controller.
→ Not currently used.
EMG:
Used to stop the NPC-10 from the host
controller.
GND:
Set to COMMON to match the DC potential
difference between the host controller and the NPC-
10.
Name and Display
Function and Description
<OUTPUT Socket>
<INPUT Socket>