13
8.
The System LED connections (Orange and Grey tagged wires)(All S4 units)
Connect the Grey and Orange wires to the same colour wires of the LED either by a soldered connection or suitable
connectors, as suits the installation.
Press the LED switch on the test box to ON. Look at the installed alarm LED; it should light when the switch is ON.
If it does not light it is possible you have connected the LED in reverse. Correct this and test again.
If it still does not light check the connections to the test box and test again.
Finally if it still does not light replace the LED and test again.
9.
The OPTIONAL supplementary siren output, max 500mA (Green/Yellow tagged wire)(All S4 units)
Connect the wire to any extra devices you may have fitted (e.g. supplementary siren, pager, texting unit, etc)
Press the extra siren button on the test box. The device should work when the button is pressed.
If it does not:
•
Check both the power LED’s of the test box are lit. The alarm fuse may have been overloaded and blown.
•
Check the connection of the Green/Yellow wire to the supplementary device.
•
Check the supplementary device is triggered by a POSITIVE not a NEGATIVE and that you have wired it
correctly and fully understand how it works.
•
Check the connections to the test box.
•
Test you are getting a positive output from the test box on the Green/Yellow tagged wire by testing it with a
suitable test light/meter.
•
If all the above is correct the fault is somewhere in the other wiring going to the supplementary device or the
device itself. Re-read the instructions for the device and correct the fault then re-test or replace as required.
Transferring the wiring and commissioning the alarm
Once the wiring harness has been fitted to the machine and fully tested by the installation tester. Disconnect the tester
and plug the alarm system onto the alarm harness.
The alarm is shipped in
‘Winter’
mode, so nothing will happen until the ignition is turned ON.
To commission the alarm, turn the ignition on and the system will start to beep with an increasing rate for 5 seconds.
After 5 seconds the alarm will sound unless disarmed by pressing the Grey button of the remote control.
On the S4 Yellow turn the ignition On then Off to wake up the system
The alarm should now be fully tested by following the operating instructions.
If any adjustments are to be made to the ways the system is to operate (e.g. adjust the movement sensor) a PIN will have
to be taught to the alarm. 1111 is the easiest to programme (follow the operating instructions).
Make the required adjustments and always advise the customer for security to set their own PIN. This can be simply
carried out by over-writing the existing PIN with the new one (any previous PIN will be deleted).
Only when you are fully satisfied the system is working correctly, fit the metal security as shown in the diagram below.
Rebuild the machine and carry out a post installation check to ensure the machine is still working correctly and no
damage has occurred during the installation.
