V110120E
iBoot-G2+
Page 22
Heartbeat
Port
9100
DxP
Port:
9100
DxP
Control:
Enabled
DxP
Query:
Disabled
Timeout:
2
set ipmode <static | dhcp>
This command sets the IP Address setting mode. Static
mode locks the address as set, dhcp mode allows DHCP
server to assign address.
set ipaddress <dotted decimal>
This command is used to set the iBoot-G2’s ip address.
192.168.1.254
set subnet <dotted decimal>
This command is used to set the iBoot-G2’s subnet
mask.
255.255.255.0
set gateway <dotted decimal>
This command is used to set the Gateway
192.168.1.1
set http port <0-65535>
This command sets the port that the iBoot-G2’s web
server listens for incoming connections on. When set to
0 the web server is disabled.
80
set telnet port <0-65535>
This command sets the port that the iBoot-G2’s Telnet
server listens for incoming connections on. When set to
0 the Telnet server is disabled
23
Set heartbeat port <0-65535>
This command sets the port for the heartbeat protocol.
The heartbeat uses UDP and can be the same port
number as DxP, which is TCP
9100
set dxp port <0-65535>
This command sets the port that the iBoot-G2’s DxP
protocol service listens for incoming connections on.
When set to 0 the Protocol service is disabled.
Note: At least one of the above MUST NOT be 0. The
CLI will protect against all 3 from being set to 0.
9100
set dxp control <enable/disable>
This command allows the main and expansion ports to
be controlled using Dataprobe Exchange Protocol (DxP)
commands.
Disabled
set dxp query <enabled/disable>
This command allows the status of the main and
expansion ports to be queried using DxP
Enabled
set timeout <0-999>
This command sets the automatic network timeout in
minutes.
2
Autoping Commands
These commands require a reboot before they will take effect.
These commands are available to the administrator only.
get autoping
This command returns all of the AutoPing settings as shown below.
Autoping
1
A
B
Status
Trigger
Count
IP
Address:
192.168.1.7
0.0.0.0
OK
0
Frequency:
10
10
Fail
Count:
3
3
Logic:
A
And
B
Action:
Cycle
Outlet:
Main
Autoping
2
Status
Trigger
Count
IP
Address:
192.168.1.6
OK
0
Frequency:
10
Fail
Count:
3
Action:
Cycle
Once
Outlet:
Exp1
Autoping
3
Status
Trigger
Count
IP
Address:
192.168.1.2
Fail
43
Frequency:
10
Fail
Count:
1
