V110120E
iBoot-G2+
Page 14
7.3. Network
Settings
IP Mode: Select Static to set the IP address using
the fields below, or DHCP to allow a DHCP server to
set the IP Address.
IP address: Enter a static IP address. This will be
automatically set if using DHCP
Subnet Mask: Enter the Subnet Mask. This will be
automatically set if using DHCP
Gateway: Enter the Gateway. This will be
automatically set if using DHCP
HTTP Port: This setting is used to allow access to
iBoot-G2+ on a port other than the Web standard Port 80. If the port is changed, you will need to identify the
port number when you enter iBoot's IP address into your browser. If the new port is 9105 then use the address
http://192.168.1.254:9105
.
Telnet Port: This setting is used to allow access to the iBoot-G2+ via telnet by ports other than standard 23.
DxP Port: This setting is used to allow access to the iBoot-G2+ via Dataprobe Exchange Protocol (DxP) via
ports other than standard 9100.
Enable DxP Control: This setting enables external devices to control the iBoot-G2+ via DxP protocol.
Enable DxP Query: This setting enables external devices to query the status of the iBoot-G2+ via DxP
protocol.
Note: All of the TCP/IP Settings require a reboot of the iBoot-G2, after clicking Save. A Reboot
button will appear at the bottom of the page. The new settings will not take effect until the unit is
rebooted. Reboot will not affect the power position of the iBoot-G2. Upon Clicking Reboot, the
Goodbye page is displayed with a link to re-login.
