Dataprobe iBoot G2+, Руководство пользователя

Страница: 21 / 28

V110120E iBoot-G2+ Page 21
Device Commands
Set commands are available to the administrator only
get location This command returns the iBoot-G2’s location ID. New Boot
set location <20 char. max> This command is used to set the iBoot-G2’s location ID.
set upgrade enable <yes | no> Enables or disables the ability to upload new firmware to
the iBoot-G2. yes
get upgrade enable This command displays the upload enable status.
logout Terminates the session
reboot This command reboots the iBoot-G2.
Expansion Commands
These commands are only available to the administrator.
get expansion This command displays the current settings of the
expansion ports. The response to this command is
determined by the expansion mode setting.
If iBoot-Exp mode:
Link
Exp 1: Yes
Exp 2: No
If Independent I/O mode:
Output
Exp1:
IP Address: 192.168.1.202
Relay: 2
Exp2:
IP Address: 192.168.1.203
Relay: 3
set expansion mode <exp | io> This command sets the mode for the expansion ports to
either iBoot-Exp or External I/O exp
set expansion <exp1 | exp2> link <yes
|no> This command sets the Exp1 or Exp2 to be linked to the
main outlet for simultaneous control. This command
takes effect only when expansion mode is exp. no
set expansion <exp1 | exp2> ipaddress
<dotted decimal> This command sets the IP address to send input status
information via DxP protocol to. This command takes
effect only when expansion mode is io.
set expansion <exp1 | exp2> relay <1-8> This command sets the relay number to be controlled by
input changes from Exp1 or Exp2. This command takes
effect only when expansion mode is io. Exp1: 2
Exp 2: 3
Network Commands
All set commands require a reboot before they take effect. These
commands are only available to the administrator.
get network
This command will return all the network settings as
shown below:
Mode: Static
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
HTTP Port: 80
Telnet Port: 23