Datalogic matrix 450N, Справочное руководство

Страница: 24 / 175

MATRIX 450N™ REFERENCE MANUAL
12
1
STEP 6
– X-PRESS CONFIGURATION
Once Matrix 450N has calibrated image density, you can configure it for optimal code
reading relative to your application. This configuration can be performed either through the X-
PRESS Interface or the DL.CODE configuration program.
Locate
1. Enter the Focus function by pressing and holding the
X-PRESS push button until the Focus LED is on.
2. Release the button to enter the Focus function. The
Blue Diamonds and laser pointers turn on.
3.
Select a code from your application . Position the
code at the center of the Horizontal FOV (aligned with
the laser pointers).
4. Exit the Focus function by pressing the X-PRESS
push button once. The Blue Diamonds and laser
pointers turn off.
Figure 14
– X-PRESS™ Interface:
Locate Function
Setup
5. Enter the Setup function by pressing and holding the
X-PRESS push button until the Setup LED is on.
6. Release the button to enter the Setup function. The
Setup LED will blink until the procedure is completed.
The Setup procedure ends when the Image
Acquisition parameters are successfully saved in the
reader memory, the Setup LED will stop blinking and
Matrix 450N emits 3 high pitched beeps.
If the calibration cannot be reached after a timeout of
about 5 (five) seconds Matrix 450N will exit without
saving the parameters to memory, the Setup LED will
stop blinking and in this case Matrix 450N emits a long
low pitched beep.
Figure 15
– X-PRESS™ Interface:
Setup Function