Datalogic matrix 450N, Справочное руководство

Страница: 23 / 175

RAPID CONFIGURATION
11
1
Setup
5. Enter the Setup function by pressing and holding the
X-PRESS push button until the Setup LED is on.
6. Release the button to enter the Setup function. The
Setup LED will blink until the procedure is completed.
The Setup procedure ends when the Image
Acquisition parameters are successfully saved in the
reader memory, the Setup LED will stop blinking and
Matrix 450N emits 3 high pitched beeps.
If the calibration cannot be reached after a timeout of
about 5 (five) seconds Matrix 450N will exit without
saving the parameters to memory, the Setup LED will
stop blinking and in this case Matrix 450N emits a long
low pitched beep.
Figure 12
– X-PRESS™ Interface:
Setup Function
Learn
7. Enter the Learn function by pressing and holding the
X-PRESS push button until the Learn LED is on.
8. Release the button to enter the Learn function. The
Learn LED will blink until the procedure is completed.
The Learn procedure ends when the Image Density
value is successfully saved in the reader memory, the
Learn LED will stop blinking, the Green Spot is
activated and Matrix 450N emits 3 high pitched beeps.
If the calibration cannot be reached after a timeout of
about 3 (three) minutes Matrix 450N will exit without
saving the parameters to memory, the Learn LED will
stop blinking and in this case Matrix 450N emits a long
low pitched beep.
Figure 13
– X-PRESS™ Interface:
Learn Function
NOTE:
You can always exit from any X-PRESS function at any time by
pressing the X-PRESS push button once. After a short delay the procedure is
cancelled.