Datalogic DS8110, Справочное руководство

Страница: 268 / 282

DS8110 REFERENCE MANUAL
256
7
Error
Code Description Severity Explanation Symptom Troubleshooting Action required
130 Encoder
Timeout Warning No encoder
(tachometer) is
detected in
specified time. The
Encoder signal
provides the
scanner with belt
speed and other
tracking
information.
This error will only
occur when the
scanner is in the
PackTrack mode.
- The scanner
may experience
an increase in
no-reads.
- The scanner
may start
missing the
transmit point.
- Confirm that the
belt is running.
- Make sure the
encoder
(tachometer)
wheel is making
a firm contact
with the
conveyor.
- Check the
Global Settings
| Diagnostics |
Encoder
Timeout
setting
to confirm that
it is not set too
low
(See section
4.5.9).
- Adjust the
encoder
(tachometer)
mounting.
- Adjust the
Encoder
Timeout
setting
(See section
4.5.9).
131 Input 1
Failure Error The Primary PS
(photoelectric
sensor) Input is
stuck in the active
state (PackTrack
Mode). - The scanner will
not go into
trigger.
- No data will be
transmitted to
the Host.
- Check the
alignment of
the
photoelectric
sensor.
- Check the
functionality of
the
photoelectric
sensor.
- Realign the
photoelectric
sensor.
- Replace the
photoelectric
sensor.
132 No Phase
Error Error No Phase
"timeout" is
exceeded (On-Line
and PackTrack
Mode).
- Trigger must be
identified within
a specified time.
133 Input 2
Failure Error Secondary PS
(photoelectric
sensor) Input
Failure Stuck Active
(PackTrack Mode). - The scanner will
not go into
trigger.
- No data will be
transmitted to
the Host.
- Check the
alignment of
the
photoelectric
sensor.
- Check the
functionality of
the
photoelectric
sensor.
- Realign the
photoelectric
sensor.
- Replace the
photoelectric
sensor.