Datalogic DS8110, Справочное руководство

Страница: 168 / 282

DS8110 REFERENCE MANUAL
156
4
Field Name Action/Definition
Aux
(Input 3) Active
Level Select Active Closed or Active Open from the drop-down list.

Active Closed : Input 3 is active when current flows through I3A/B pins.

Active Open : Input 3 is active when there is no current flowing through I3A/B
pins.
NOTE : This parameter setting is not valid, if the
input has already been defined in On Line or
PackTrack Operating Modes .
Digital Output Lines
Select Digital
Output Number
to View/
Modify Select the number of the output you will view or modify from the drop-down list.
Digital Output n
Digital Output n
Use
Select Local , EthernetIP , or Profibus/Profinet from the drop-down list. This
parameter selects the source that drives the digital output. Local output is driven by
the device application program. EithernetIP is driven by the EtherNet/IP Host and
Profibus/Profinet is driven by the relative Fieldbus Host.
Digital
Output
n
Line State
Select Normally Open or Normally Closed from the drop-down list.
Each output can be represented with an NPN transistor; this transistor acts like a
switch: so, when the transistor is OFF , it acts like an OPEN switch. On the contrary,
when the transistor is ON , it acts like a CLOSED switch.

Normally Open : The idle state of the output line is open, that is, the NPN
transistor is OFF (like an open switch).When the output is activated, the transistor
goes ON (like a closed switch).

Normally Closed : The idle state of the output line is closed, that is, the NPN
transistor is ON (like a closed switch).When the output is activated, the transistor
goes OFF (like an open switch).
Activation
Primary
Activation
Event Select a Primary Activation Event from the drop-down list (see below).

None : The output is always in line state.

Complete Read : The event occurs, if all selected codes are read.

Partial Read : The event occurs, if less than the selected codes are
read.

No Read : The event occurs, if no code is read.

Trigger On : The event occurs, when a start event takes place
starting the reading phase.

Trigger Off : The event occurs, when a stop event takes place
ending the reading phase.

Multiple Read : The event occurs, if a code is read more than once
consecutively.

Right/Match : The event occurs, if a code is successfully decoded
and matches the Match Code (Verifier Code).

Wrong/No Match : The event occurs, if a code is successfully
decoded but does not match the Match Code (Verifier Code).