Datalogic A30, Руководство по оборудованию

Страница: 25 / 64

CBX ELECTRICAL CONNECTIONS
15
4
4.2 RS232 SERIAL INTERFACE
The signals relative to the following serial interface types are available on the CBX spring clamp
terminal blocks.
The serial interface parameters (baud rate, data bits, etc.) are defined in Vision Program
Manager (VPM) software. Refer to the Serial Port section of the Impact Reference Guide
(Publication # 843-0093).
The following pins are used for RS232 interface connection. The Impact software does not
support hardware (CTS/RTS) or software (Xon/Xoff) data flow control.
CBX500 Function
TX Transmit Data
RX Receive Data
SGND Signal Ground
It is always advisable to use shielded cables. The overall maximum cable length must be less
than 15 m (49.2 ft.).
Figure 13 – RS232 Main Interface Connections Using Hardware Handshaking
4.2.1 RS485 Full-Duplex Interface
The Impact software does not support RS485 protocol.
4.3 AUXILIARY RS232 SERIAL INTERFACE
The 9-pin female Auxiliary Interface connector inside the CBX is to be used by Factory and
Support personnel only.
NOTE
Do not make any connections to the Aux Interface.