Datalogic A30, Руководство по оборудованию

Страница: 34 / 64

A30™ HARDWARE GUIDE
24
5
5 CAMERA ELECTRICAL CONNECTIONS
5.1 POWER, SERIAL, AND I/O CONNECTOR
The camera is equipped with an M16 19-pin male connector (Binder, 423 Series) for connection
to the power supply, serial interface and input/output signals. The details of the 19- pin and 25-
pin connectors on the cable are shown in the following table. The camera cannot source
power through this connector .
Figure 27 – M16 19-pin Connector (Pin Side) 25-pin D-Sub Connector (Pin Side)
Connector Pinout
25-Pin 19-Pin Wire Color Name Function
9 & 13 A Red Vdc Power supply input v
7 & 25 L Black GND Power supply input voltage -
18 B Orange I1A External Trigger A (polarity insensitive)
19 C Green-Black I1B External Trigger B (polarity insensitive)
6 D Grey I2A Input 2 A (polarity insensitive)
10 E Green-Red I2B Input 2 B (polarity insensitive)
22 F Black-White O1- Output 1 -
11 G White-Red O2+ Output 2 +
8 H Purple O1+ Output 1 +
12 I White-Blue O2- Output 2 -
2 M Yellow TX RS232 Transmit
3 U Brown RX RS232 Receive
4 N Pink Not Used
5 T Green Not Used
21 O Yellow-White Not Used
20 S Yellow-Blue Not Used
17 R White Strobe-/O3B Strobe - / Output 3 –
(See Note)
16 P Blue /O3A / Output 3 +
1 K Shields CHASSIS
Cable shield internally connected by
capacitor to the chassis in CBX500
Note: The strobe signal connection is shared with Output 3. If a non-zero value is defined for the Strobe Pulse Length
value (in VPM – Impact – General), the strobe is active. If the value is zero, Output 3 is active.