Datalogic A30, Руководство по оборудованию

Страница: 57 / 64

TROUBLESHOOTING
47
10
10 TROUBLESHOOTING
10.1 GENERAL GUIDELINES
•
When wiring the device, pay careful attention to the signal name on the CBX500 spring clamp
connectors (chapter. 1). If you are connecting directly to the A30 M16 19-pin connector, pay
attention to the pin number of the signals (chapter. 1).
•
If you need information about a certain camera parameter, you can refer to the Impact
Reference Guide.
•
If you’re unable to fix the problem and you’re going to contact your local DLA office, DLA
Partner or ARC, we suggest providing (if possible) the Software version, Parameter
Configuration file, Serial Number and Order Number of your camera. You can get some of this
information in VPM while it is connected to the camera. The software version is shown in the
About dialog and the Serial Number can be obtained from the Device Connection dialog.
TROUBLESHOOTING GUIDE
Problem Suggestion
Power ON:
the “POWER” LED is not lit.
•
Is power connected?
•
If using a power adapter (like PG-120), is it connected
to wall outlet?
•
If using rail power, does rail have power?
•
If using CBX, does it have power (check switch and
LED)?
•
Check if you are using the M16 19-pin connector or the
CBX spring clamp connectors.
•
Measure Voltage either at pin A and pin L (for 19-pin
connector) or at spring clamp Vdc and GND (for CBX).
Using the Input 1 (External
Trigger) or Input 2:
the ”BUSY” LED is not blinking
while the External Trigger is
switching.
•
Check if you are using the 19-pin connector or the CBX
spring clamp connectors.
•
Is the sensor connected to the Input 1 or Input 2?
•
Is power supplied to the photo sensor?
•
For NPN configuration, is power supplied to one of the
two I1 or I2 signals (A or B)?
•
For PNP configuration, is one of the two I1 or I2 signals
grounded (A or B)?
•
Is the sensor/reflector system aligned (if present)?
•
In VPM, check the EXTERNAL TRIGGER or INPUT 2
Debounce Filter parameter setting.
•
In VPM, check the Camera Trigger settings.