- 99 -
The unit can be programmed to enter RUN mode when a Remote Start signal is received, and to enter STOP
mode when the signal is not received.
Any digital input can be programmed as
Remote Start/Stop
signal. This operation can be performed
from the
Input Configuration
program menu.
If the unit is used in a single-phase electrical network, it is advised to select the topology as
1 Phase 2
Wire
.
When the topology is set to
1 Phase 2 Wire,
the unit will measure electrical parameters only on
L1
phase
only.
In a similar manner, over current and voltage checks and protections will be performed only on phase
L1.
L2
and
L3
phase measurements will not be displayed on screen.
The controller offers externally controllable digital output functions. To enable this feature, the digital
outputs must be set to one of the
“User output X” functions.
These functions have no effect on device operation.
These outputs can be remote controlled via Modbus, Modbus TCP/IP, and Rainbow Scada.
If necessary, the controller may be manually reset by holding the STOP button pressed for 30 seconds.
The manual reset will cause the hardware to be configured according to new settings.
It is advised to manually reset or power off/on cycle the device after every hardware configuration
modification.
21.4. RESETTING THE CONTROLLER
21.1. REMOTE START
21.3. EXTERNALLY CONTROLLED DIGITAL OUTPUTS
21.2. SINGLE PHASE OPERATION
21. SOFTWARE FEATURES
Содержание DK-70
Страница 10: ...10 Dimensions 211x162x42mm Panel cutout 176x121mm minimum Weight 500g approx 2 1 DIMENSIONS 2 MOUNTING...
Страница 31: ...31 4 4 3 PHASE 3 WIRE DELTA 2 CT L1 L3 4 3 3 PHASE 3 WIRE DELTA 2 CT L1 L2...
Страница 32: ...32 4 6 1 PHASE 2 WIRE 4 5 2 PHASE 3 WIRE DELTA 2 CTs L1 L2...
Страница 33: ...33 5 CONNECTION DIAGRAM...
