Datakom DK-70, Руководство пользователя

Страница: 64 / 121

- 64 -
Parameter Definition Unit Min Max Factory
Setting
Description
SMS Commands
Enabled
- 0 1 1
0: SMS commands not accepted
1: SMS commands accepted only from
listed telephone numbers.
Periodic Event Recording
Enabled
- 0 1 0
0: No periodic (hourly) event records.
1: Periodic (hourly) event records
enabled.
PGM Entered Event - 0 1 1
0: No event recorded upon entering
programming mode.
1: Event recorded upon entering program
mode.
Temperature Display
Fahrenheit
- 0 1 0
0: Temperature measurements are
displayed in degrees Celsius
(°C).
1: Temperature measurements are
displayed in degrees Fahrenheit
(°F).
Pressure Display PSI - 0 1 0
0: Pressure measurements are displayed
in Bar .
1: Pressure measurements are displayed
in PSI .
Current Transformer
Secondary
- 0 1 0
0: xxx/5A
1: xxx/1A
Compressor Fan Stop
Together
- 0 1 1
0: When the compressor turns off,
“Fan
OFF Temperature
” is checked to turn off
the fan.
1: The fan turns off with the compressor.
Local Time Zone Hours -12 +12 3
This parameter selects the time zone for
the location of the unit. This allows the
real time clock to be synchronized to UTC.
GSM Location Info - 0 1 1
0: Location over GSM disabled.
1: Location over GSM enabled.
T1 Upload Sender Curve
T2 Upload Sender Curve
T3 Upload Sender Curve
T4 Upload Sender Curve
- 0 6 0
These parameters enable the upload of
the below 16-point ohm-temperature
sender curves for the senders 1,2,3, 4.
0: No Upload: If the sender curve will not
be changed, this value must be selected.
1: KTY 13.5 R25=2K sender curve
uploaded.
2: KTY R25=1K sender curve uploaded.
3: PT1000 sender curve uploaded.
4: NTC R25=10K B=3435K sender curve
uploaded.
5: NTC R25=10K B=3760K sender curve
uploaded.
6: NTC R25=10K B=3950K sender curve
uploaded.
15.1. CONTROLLER CONFIGURATION GROUP (cont.)