Datakom DK-70, Руководство пользователя

Страница: 114 / 121

- 114 -
ADDRESS
(decimal)
R / W DATA COEFF. DESCRIPTION
8192 W 16bit x1 Password (In order to change calibration coefficients over
Modbus, the calibration password must be entered here.)
8193 W 16bit x1 Button simulation. If the following hexadecimal values are
entered to this address, the unit responds as if the
corresponding buttons were pressed.
0x8001: Stop very long press
0x8010: Run very long press
0x8080: Right very long press
0x8100: Left very long press
0x8200: Up very long press
0x8400: Down very long press
0x4001: Stop long press
0x4010: Run long press
0x4080: Right long press
0x4100: Left long press
0x4200: Up long press
0x4400: Down long press
0x1001: Stop short press
0x1010: Run short press
0x1080: Right short press
0x1100: Left short press
0x1200: Up short press
0x1400: Down short press
8194 W 16bit x1 Harmonic channel selection. If the following decimals are
entered into this address, the corresponding harmonic channel
is selected.
0: Phase L1 voltage
1: Phase L2 voltage
2: Phase L3 voltage
6: Phase L1-L2 voltage
7: Phase L2-L3 voltage
8: Phase L3-L1 voltage
12: Phase L1 current
13: Phase L2 current
14: Phase L3 current
8195 W 16bit x1 Factory Reset. If the decimal 43690 is entered into this addres,
the unit resets to factory defaults. Service counters are reset;
other counters are not reset.
8196 W 16bit x1 Reset counters. If the following decimals are entered into this
address, the corresponding counter is reset.
1: Reset Active power (kWh) counter.
4: Reset Inductive reactive power (kVArh) counter.
8: Reset Capacitive reactive power (kVArh) counter.
16: Reset Digital input pulse counter-1.
32: Reset Digital input pulse counter-2.
64: Reset Running Hours counter.
128: Reset Loaded Running Hours counter.
256: Reset Number of motor starts counter.
512: Reset Number of fan starts counter.
1024: Oiling Counter set equal to Oiling Period parameter.
22.4. COMMANDS