Copyright © 2008 – 2019 DARE!! International
Page 22
10.
Under the “RadiSense’ tab the RadiSense 10 can be configured to provide isotropic field
strength measurements of all three axes or if individual (single) axis measurements are
being performed. Furthermore, the filter settings can be configured.
11.
Upon completion of the settings click on ‘OK’.
12.
After clicking ‘OK’ you will go back into the device driver settings window. The
communication can now be verified by clicking the ‘Check’ button on the right.
13.
If all settings are correct, the message ‘The check for the device connection has
passed’ will be shown. If an error is shown, please check and repeat the previous
software configuration steps 1 to 12.
RadiMation is now ready for use with the RadiSense / RadiCentre field sensor.
The RadiMation software package verifies the field sensor at the beginning of each test (if a field
sensor is selected).
If you are using the RadiSense / RadiCentre field sensor system with any other EMC test software
package, we refer you to chapter 6 ‘RadiSense Command Set’.
