Copyright © 2008 – 2019 DARE!! International
Page 9
2.3
Fibre Optic Cables
Use an extension fibre to connect the sensors to the plug-in card mounted in the RadiCentre.
This extension fibre is a robust duplex fibre cable and uses dissimilar connectors to avoid
misconnections. The fibre optic cable with FC connectors feeds LASER light to the field sensor.
The fibre optic cable with ST connectors is used for bi-directional data communication between
the field sensor and the plug-in card.
Refer to chapter 2.6 for fibre handling and maintenance.
To ensure safe and correct operation of the sensor, only use the RadiSense
with the original
supplied or ordered fibres. Do not use other fibres than those supplied by DARE!! Instruments.
Fibre extension cables with different lengths up to 100 meters are available on request.
Contact your local reseller for more detailed information.
2.4
RadiSupply Plug-In Card, Rear Panel
The following connections and indicators are found at the back panel of the RadiSupply
plug-in
card:
POWER ON:
This green LED lights up when the power is on and the
interlock is closed
2
.
LASER APERTURE: Connect to the E-field sensor through the fibre
extension cable with FC connectors.
LASER ON:
This red LED lights up when the LASER is active.
OPTICAL DATA LINK: Connect to the E-field sensor through the fibre extension
cable with ST connectors.
2
If the green LED is off, check the power supply and the interlock connection
