Pag
e
27
40
If the wheel's static imbalance is less than 12 grams, the
ERR 055
error message
will appear and it will automatically exit the optimisation programme. If, on the
other hand the wheel's static imbalance is greater than 12 grams, the machine
will start the OPTIMISATION programme.
50
Position the valve at 12 o'clock, make a mark on the tyre where the valve is and
press [6] on the keyboard.
60
Remove the wheel from the shaft, remove the t
i
re bead, rotate it so that the
mark is at 180° with respect to the valve.
Re-install the wheel on the shaft, and erase the mark made previously.
Lower the wheel guard: the machine will run a launch.
70
At the end of the launch, place the valve at 12 o'clock and press [6] on the
keyboard to continue. In this case the message seen in the figure for the next
phase will appear.
80
Rotate the wheel until all position arrow LEDs light up and then mark the 12
o’clock position and press key [6] on the keyboard.
90
Remove the wheel from the balancing machine, remove the bead from the t
i
re
and rotate it until the valve matches the mark on the t
i
re.
Optimisation is
finished: exit the
optimisation menu by pressing [5].
100
Remount the wheel on the balancing machine and balance it with the normal
procedure.
