![background image](http://html1.mh-extra.com/html/dannmar/b-200/b-200_installation-and-user-manual_3431447012.webp)
Pag
e
10
11. KEYBOARD
In this manual, the keys are numbered for convenience from [1] to [9] as shown in picture F11.1. The nine keys have only one
primary function.
Picture F11.1: Keyboard
Table T11.1: Functions of the keys
Pos.
Description
1 – 2 – 3 - 4
Function selection keys.
5
“Back” key to go back to the previous view.
6
“Enter” key to confirm selection.
7
Quick menu( control illuminator)
8
“Start” key to start the motor.
9
“Stop” key to stop the motor.
STAND BY led
Machine status led.
12. OPERATING MODES STANDARD, SERVICE, STAND-BY
The machine features three operating modes:
STANDARD mode. This mode is enabled after the machine is turned on and it is possible to perform the wheels balancing;
SERVICE mode. In this mode various utility programs are available for setting parameters (such as grams or ounces) or
checking the machine operations (such calibration);
STAND-BY mode. After 5 minutes without user activity, the machine automatically switch to STAND-BY mode to reduce
electrical consumption (both with wheel guard raised or lowered). The STAND-BY green led on the control panel is
blinking it means the machine is in this operating mode. All acquired data and settings are held in STAND-BY mode. In the
SERVICE mode is not possible to switch to STAND-BY mode.
To exit from STAND-BY mode choose by any of the following means:
Press any keys;
Turn manually the wheel;
Pull out the distance/diameter sensor from idle position (only for the models with automatic acquisition of
distance/diameter);
Pull out the external sensor from idle position (only for the models with automatic acquisition of width.
Note: the machine exits the STAND-BY mode also by pressing the key [8] Start or lowering the wheel guard. In these cases
simultaneously
will be start also the spinning (if you press [8] Start the spin will start only if the wheel guard is already lowered).
2
3
1
4
7
5
6
8
9