![background image](http://html1.mh-extra.com/html/dannmar/b-200/b-200_installation-and-user-manual_3431447027.webp)
Pag
e
25
14.4.1 Balancing spin
To perform the balancing spin, proceed as follows:
Op.
Description
10
Lower the wheel guard to run the balancing launch. Once the spin
cycle is completed, the imbalance values calculated, according to
the balancing planes chosen, will be displayed.
20
The machine also automatically sets the Search mode of the
balancing planes.
ALS1
ALS2
14.4.2 Search of the balancing planes
The purpose of the balancing planes research is to find the balancing planes which were previously selected by the operator in
order to apply the balancing weights. Proceed as follows:
Op.
Description
10
Apply the weight shown on the left display (internal
position) on top of the Distance/Diameter sensor
gauge as shown here.
20
Manually rotate the wheel until all the internal
imbalance position leds light up (see figure here).
Block the wheel in this position with the help of the
pedal brake (if installed) or the electromagnetic
brake.
30
Slowly extract the sensor until you hear the
continuous beep indicating that the internal balancing
plane has been reached. The blue band represents
the application point of the internal weight.
40
Block the Distance/Diameter sensor at this distance,
then, rotate it until the adhesive weight sticks on the
rim. The sensor contact point will be a midway
position between 12 o’clock and 6 o’clock, depending
on the rim diameter.
A
B
C
Adhesive surface