[19]
Freeze ref
Freezes the actual reference, which is now the point of enable/condition for Speed up and Speed
down to be used. If Speed up/down is used, the speed change always follows ramp 2 (par. E-10 Ac-
cel
Time 2
and par. E-11 Decel
Time 2
) in the range 0 - par. F-53 Maximum
Reference
.
[20]
Freeze output
Freezes the actual motor frequency (Hz), which is now the point of enable/condition for Speed up
and Speed down to be used. If Speed up/down is used, the speed change always follows ramp 2
(par. E-10 Accel
Time 2
and par. E-11 Decel
Time 2
) in the range 0 - par. F-04 Base
Frequency
.
NB!
When Freeze output is active, the frequency converter cannot be stopped via a
low ‘start [8]’ signal. Stop the frequency converter via a terminal programmed
for Coasting inverse [2] or Coast and reset, inverse.
[21]
Speed up
Select Speed up and Speed down if digital control of the up/down speed is desired (motor poten-
tiometer). Activate this function by selecting either Freeze reference or Freeze output. When Speed
up/ down is activated for less than 400 msec. the resulting reference will be increased/ decreased
by 0.1 %. If Speed up/ down is activated for more than 400 msec. the resulting reference will follow
the setting in ramping up/ down parameter 3-x1/ 3-x2.
Shut down
Catch up
Unchanged speed
0
0
Reduced by %-value
1
0
Increased by %-value
0
1
Reduced by %-value
1
1
[22]
Speed down
Same as Speed up [21].
[23]
Set-up select bit 0
Select Set-up select bit 0 or Select Set-up select bit 1 to select one of the four set-ups. Set par.
K-10 Active
Set-up
to Multi Set-up.
[24]
Set-up select bit 1
(Default Digital input 32): Same as Set-up select bit 0 [23].
[26]
Precise stop inv.
Prolongs stop signal to give a precise stop independent of speed.
Sends an inverted stop signal when the precise stop function is activated in par. H-83 Precise
Stop
Function
.
Precise stop inverse function is available for terminals 18 or 19.
[27]
Precise start, stop
Use when Precise ramp stop [0] is selected in par 1-83.
[28]
Catch up
Increases reference value by percentage (relative) set in par. F-62 Catch
up/slow Down Value
.
[29]
Slow down
Reduces reference value by percentage (relative) set in par. F-62 Catch
up/slow Down Value
.
[30]
Counter input
Precise stop function in par. H-83 Precise
Stop Function
acts as Counter stop or speed compensated
counter stop with or without reset. The counter value must be set in par. H-84 Precise
Stop Counter
Value
.
[32]
Pulse input
Use pulse sequence as either reference or feedback. Scaling is done in par. group 5-5*.
[34]
Ramp bit 0
Enables a choice between one of the 4 ramps available, according to the table below.
[35]
Ramp bit 1
Same as Ramp bit 0.
FC 300 Extended Relay Card Operating In-
structions
5. Parameter Set-up
MI.33.G2.02 - VLT
®
is a registered Danfoss trademark
13
5