Danfoss VLT AutomationDrive FC 360, Руководство по конструкции

Страница: 4 / 88

2.5.2 Process PID Control 32
2.5.3 Process Control Relevant Parameters 33
2.5.4 Example of Process PID Control 34
2.5.5 Optimisation of the Process Regulator 36
2.5.6 Ziegler Nichols Tuning Method 36
2.6 EMC Emission and Immunity 37
2.6.1 General Aspects of EMC Emission 37
2.6.2 EMC Emission Requirements 38
2.6.3 EMC Immunity Requirements 38
2.7 Galvanic Isolation
40
2.8 Earth Leakage Current
40
2.9 Brake Functions
41
2.9.1 Mechanical Holding Brake 41
2.9.2 Dynamic Braking 42
2.9.3 Brake Resistor Selection 42
2.10 Smart Logic Controller
44
2.11 Extreme Running Conditions 44
3 Type Code and Selection
46
3.1 Ordering
46
3.2 Ordering Numbers: Options and Accessories
47
3.3 Ordering Numbers: Brake Resistors
48
3.3.1 Ordering Numbers: Brake Resistors 10% 48
3.3.2 Ordering Numbers: Brake Resistors 40% 49
4 Specifications
50
4.1 Power-dependent Specifications
50
4.2 General Specifications
52
4.3 Fuses 56
4.3.1 Introduction 56
4.3.2 CE Compliance 56
4.4 Efficiency 57
4.5 Acoustic Noise 57
4.6 dU/dt Conditions 57
4.7 Special Conditions 59
4.7.1 Manual Derating 59
4.7.2 Automatic Derating 59
5 RS485 Installation and Set-up
60
5.1 Introduction 60
5.1.1 Overview 60
Contents Design Guide
2 Danfoss A/S © 09/2014 All rights reserved. MG06B402