Danfoss VLT AAF00x, Руководство по эксплуатации

Страница: 53 / 103

6.1.4 Q2 Quick Setup
The parameters in Q2 Quick Setup are the basic
parameters which are always needed to set up the Active
Filter to operation.
Q2 Quick Setup
Parameter number and
Name
Factory default
0-01 Language English
300-22 CT Nominal Voltage Same as AF
300-29 Start Auto CT
Detection Off
300-01 Compensation
Priority Harmonics
300-00 Harmonic Cancel-
lation Mode Overall
NOTE
It is necessary to set the nominal voltage and CT
Secondary rating, as well as change
300-26 CT Placement to
PCC, before the Auto CT detection is started. Auto CT
detection is only possible if CTs are located at the point of
common coupling.
6.1.5 Q5 Changes Made
Q5 Changes Made can be used for fault finding.
Select Changes made to get information about:
- • the last ten changes. Use the up/down
navigation keys to scroll between the last ten
changed parameters.
- the changes made since default setting.
6.1.6 Q6 Loggings
Q6 Loggings can be used for fault finding.
Select Loggings to get information about the display line
readouts. The information is shown as graphs. Only display
parameters selected in
0-20 Display Line 1.1 Small and
0-24 Display Line 3 Large can be viewed. It is possible to
store up to 120 samples in the memory for later reference.
Please notice that the parameters listed in the below table
for Q6 only serve as examples as they will vary depending
on the programming of the particular Active Filter.
Q6 Loggings
0-20 Display Line 1.1 Small Power Factor
0-21 Display Line 1.2 Small THD of current
0-22 Display Line 1.3 Small Mains Current
0-23 Display Line 2 Large Output Current
0-24 Display Line 3 Large Mains Frequency
6.1.7 Main Menu mode
The LCP provide access to the main menu mode. Select
the Main Menu mode by pressing the [Main Menu] key.
shows the resulting readout, which appears on the display
of the GLCP.
Lines 2 through 5 on the display show a list of parameter
groups which can be chosen by toggling the up and down
buttons.
Each parameter has a name and number which remain the
same regardless of the programming mode. In the Main
Menu mode, the parameters are divided into groups. The
first digit of the parameter number (from the left) indicates
the parameter group number. All parameters can be
changed in the Main Menu. Option cards added to the
unit enable additional parameters associated with the
option device.
How to Programme VLT Active Filter AAF 00x
52 MG.90.V2.02 - VLT® is a registered Danfoss trademark
6 6