Danaher Motion SuperDrive ACS24 Series, Руководство пользователя

Страница: 71 / 99

26.04.2005
Troubleshooting guide
•
When using a troubleshooting chart, one should first investigate those possible causes, which
seem most likely considering the recent history of the vehicle.
Locate the observed symptom(s) in Table 26 , error code in Table 27 and warning code in Table
28 , and then refer to the troubleshooting chart on the referenced page. After performing a
corrective action, restart the AC SuperDrive and verify that the error/warnì
Locate the observed symptom(s) in Table 26 , error code in Table 27 and warning code in Table
28 , and then refer to the troubleshooting chart on the referenced page. After performing a
corrective action, restart the AC SuperDrive and verify that the error/warning does not reoccur. If
the error/warning does reoccur, proceed to the next corrective action on the troubleshooting
chart.
Symptom code See page
Main contactor doesn’t close within 10 seconds after switching on
key switch.
73
Fuse to Power Stage is blown. 74
AC SuperDrive Status indicator is blinking or off.
75
Motor runs only at low speed, with a ticking sound.
76
Table 26. Symptom versus Troubleshooting Chart.
Emergency
Error code
Extended
Errors bit field
code index
3010h,2
Error See
page
0x2310 0x2000 AC Current - Over current.
83
0x2340 0x0001 AC Current – Short circuit.
83
0x3120 0x0010 No Charging DC Bus.
85
0x3211 0x0004 DC Bus high – software detected. 84
0x3212 0x0008 DC Bus high – hardware detected.
84
0x3221 0x0002 DC Bus low.
85
0x4210 0x0020 Motor temperature high. 78
0x4310 0x0040 / 0x0080 Heatsink Over temperature.
80
0x5111 0x0400 15 V Supply low voltage
90
0x5113 0x0800 15 V Supply low or high voltage
90
0x5210 0x0200 Current sensors offset calibration error
90
0x5410 0x1000 Open Drain Output Current High NA
0x8100 0x0100 CAN Time Out.
86
Table 27. Error versus Troubleshooting Chart.
User's Guide 1.0 Item No. 89Y05120A
71