Installation
1
1 Installation
Radio Receiver
The radio receiver has hook-and-loop fastener strips to secure it to the inside of the
scoreboard. Most outdoor scoreboards also have an internal mounting bracket to which
the radio receiver can attach. Refer to the component location drawings included in the
scoreboard manual for the exact radio mounting location.
Indoor Scoreboards
Reference Drawings:
Installation Diagram; Indoor Scbd Gen VI Radio Receiver .........................
DWG-1109105
Radio Installation Details; Scoreboards .........................................................
DWG-1130990
Radio Installation Pattern; Scoreboards ........................................................
DWG-1166771
For standard indoor scoreboards (Tuff Sport
®
& ColorSmart
®
), refer to
DWG-1109105
.
Note:
For scoreboards built after March 2013, refer also to
DWG-1130990
. These
scoreboards have mounting holes for U bolts that protect the antenna. If holes
need to be drilled into the scoreboard, use
DWG-1166771
as a guide.
Radio/Wire Switch
Reference Drawings:
Install Details; Indoor Radio/Wire Switch ..........................................................
DWG-168045
For indoor installations that have a radio/wire switch, refer to
DWG-168045
.
Outdoor Scoreboards
Reference Drawings:
Installation Drawing; Outdoor Scbd Gen VI Radio Receiver ......................
DWG-1109181
Outdoor Installation; Gen VI Radio & Base Station ......................................
DWG-1109252
For standard outdoor scoreboards, refer to
DWG-1109181
.
In certain situations, it is possible that both an All Sport
®
radio receiver and an RC-100
base station will be installed in the same scoreboard. For instance, a handheld RC-100
controller may be used when running practices, and then a wireless All Sport console
controls the scoreboard during real games. In these cases, refer to
DWG-1109252
. The
wireless device that takes precedence is the one that the scoreboard receiver finds
active first, and it will control the scoreboard until the signal is no longer present.
Note:
For dual-radio setups, Gen VI radio receiver requires firmware
Version 1�4
or
greater, and RC-100 base station requires firmware
Version 3�7
or greater.
Radio Antenna Extension Kit
An optional radio antenna extension kit (Daktronics part # 0A-1196-0243) is used to help
ensure a better line-of-sight from the console to the scoreboard. For more information,
refer to the
Remote Antenna Installation Quick Guide (DD3548818)
, available online at
Содержание GEN VI RADIO P1110
