Daktronics GEN VI RADIO P1110, Руководство по установке

Страница: 7 / 34

Setting Radio Channels
3
3� The console will ask to Resume Game? – select one of the following choices:
• [Yes] – The console immediately begins sending information over the radio link, using
the channel it was set to when last shut off.
• [No] - (see below)
a� After entering or accepting the Sport Code, the console checks if the radio is
installed. If detected, the console displays the current Broadcast and Channel
numbers.
b� Accepting the listed values results in no changes to the radio, and the console
begins sending information over the radio link.
c� Changing the listed values updates the settings, and the console begins sending
data over the radio link on the new channel.
Refer to Typical Radio Configurations (p.5) for information about changing the radio
settings in the console.
Figure 2 shows the LED indicators on the radio transmitter, located on the rear of the
console.
•
STATUS (amber LED) – Should always be
ON when installed in a console ; signifies
that the radio is operating in Server
Mode
• DATA (red LED) – Active when data is
received from the console and passed
to the radio transmitter
• POWER (green LED) – Illuminates when power is applied to the transmitter
Client (Scoreboard)
Reference Drawings:
Installation Diagram; Indoor Scbd Gen VI Radio Receiver ......................... DWG-1109105
Installation Drawing; Outdoor Scbd Gen VI Radio Receiver ...................... DWG-1109181
To locate and access the receiver, refer to the service documentation for the particular
scoreboard model.
1� Power ON – the POWER indicator (green LED) illuminates.
2� After an approximately seven-second delay to allow the scoreboard to perform
a segment test, “b# C#” displays on the scoreboard, followed by “US” or “EU”
depending on region.
•
“US” – Domestic (US/Canada) radio with a higher transmission power and access
to all Broadcast Groups.
• “EU” – International (Europe/UK etc) radio with a lower transmission power and
access to Broadcast Groups 1-4 only.
Note: Mixed radio types are not compatible.
RADIO
STATUS DATA POWER
Figure 2: Radio Transmitter (on Rear of Console)