Daktronics GEN VI RADIO P1110, Руководство по установке

Страница: 15 / 34

Troubleshooting
11
Display Action
MENU- MAIN ENTER
DISPLAY MENU?
MENU-DISPLAY
RADIO TEST?
EXIT GAME
ARE YOU SURE?
After the main clock has been stopped, press the <MENU>
key and press the down or up arrows until the LCD at top left is
displayed. Press <ENTER> to enter the display menu.
Press the down or up arrows until the LCD at center left is
displayed. Press <ENTER> to exit the current game in progress
and enter the radio diagnostics menu.
Note: The console will prompt to press <ENTER> a second time
to avoid accidental exit from the sport program.
RADIO TEST
-SIGNAL LEVEL
SIGNAL LEVEL
ANY KEY TO EXIT
Press <ENTER> to begin the signal level test, or press the down or
up arrows to select another test.
This test sends a command to the radio receiver in the
scoreboard to show its signal level on the first 2 clock digits*. The
signal level can range from ’00’ (weakest) to ‘99’ (strongest).
The value of ‘00’ would indicate there is no server in range.
For scoreboards with 4-digit clocks, the 2 right clock digits* will
also show the missed packet count during this test (see section
below). Press any key to exit the test.
RADIO TEST
-MISSED PACKET
MISSED PACKET
ANY KEY TO EXIT
Press <ENTER> to begin the missed packet test, or press the
down or up arrows to select another test.
This test sends a command to the radio receiver in the
scoreboard to show the number of missed packets on the first
2 clock digits*. The missed packet count ranges from ‘00’ to
‘99’ and indicates the number of missed packets since the start
of the test. Ideally, the number should be ‘00’ to indicate no
missing packets. A larger number indicates that there are some
signal issues, either with signal level or noise interference. For
scoreboards with 4-digit clocks, the 2 right clock digits* will also
show the signal level during this test (see previous section). Press
any key to exit the test.
RADIO TEST
-RADIO CHAN
BCAST X CHAN Y
ANY KEY TO EXIT
X = broadcast number
Y = channel number
Press <ENTER> to begin the radio channel test, or press the down
or up arrows to select another test.
This test shows the current Broadcast Group and Channel
number settings in the console. This test also sends a command
to the radio receiver in the scoreboard to show the receiver’s
settings on the first 2 clock digits* by alternating between “bX”
and “CY”, where X is the current Broadcast Group and Y is
the current Channel. Use this menu to verify the console and
scoreboard radio settings. Press any key to exit the test.
RADIO TEST
-SERVER VER
SERVER VER X.Y
ANY KEY TO EXIT
X = firmware major number
Y = firmware minor number
Press <ENTER> to begin the server test, or press the down or up
arrows to select another test.
This test shows the console’s radio firmware version number.
This test also sends a command to the radio receiver in the
scoreboard to show the receiver’s firmware version number on
the first 2 clock digits* by alternating between “rX” and “_Y”,
where _ is a blank digit. For example, version 1.3 would display
as “r1” followed by ”_3”. Press any key to exit the test.