21
Advanced Settings
Advanced Settings
AUTO operation lamp
HUM lamp (High)
HUM lamp (Low)
Note
Settings are remembered even if the unit is unplugged.
Active Plasma Ion Output Settings
If the smell of ozone bothers you
Active plasma ion generation operation can be turned “OFF”. (Setting at the time of purchase: ON)
Settings are remembered even if the unit is unplugged.
• If the odour of ozone continues to bother you even after output has been set to OFF, set streamer output to Low.
►
Page 22
1.
Hold down
for about 5 seconds and when a short beep sounds, press
while pressing
.
(Setting can be performed either during operation or while operation is stopped.)
2.
When a short beep sounds, release
and
.
• The AUTO operation lamp (green) blinks for about 5 seconds and
then lights up.
• One of the HUM lamps “ (Low)/
(High)”, will blink for about
5 seconds and then the lamp corresponding to the current setting will
light up.
Current
setting
HUM lamp
(Low)
HUM lamp
(High)
ON
OFF
Lit up
OFF
Lit up
OFF
3.
Press
to change the output settings.
• Each press cycles between active plasma ion generation operation “ON” and “OFF”.
(The AUTO operation lamp (green) will remain lit up.)
• If the lamp does not change, unplug the unit, wait at least 5 seconds, then re-insert the power supply plug and repeat the
above procedure from the beginning.
4.
Press
after selecting the new setting.
• A short beep sounds and the AUTO operation lamp (green) will blink.
• The HUM lamp “ (Low)/
(High)” blinks depending on the setting.
Operation
setting
HUM lamp
(Low)
HUM lamp
(High)
ON
OFF
Blinking
OFF
Blinking
OFF
5.
While the lamp is blinking, unplug the power supply plug, wait at least 5 seconds, and then insert the
power supply plug again. Setting is now complete.
• If this procedure is not performed, the unit will not return to regular operation mode.
Operating panel
