29
Maintenance
Maintenance
WARNING
Before cleaning and maintenance work, be sure to unplug
the unit. (An electric shock or injury may result)
Humidifying Tray
Wash/Rinse
About every 3 days or when odour or dirt becomes
an issue
Clean with water.
• Use a soft cloth or brush to clean hard-to-reach places.
• For areas with water scales, remove the water scales with
a soft cloth or brush soaked in lukewarm or room
temperature water in which citric acid has been dissolved.
When removing water scales, be careful not to get
the silver ion cartridge wet.
Finally, rinse with water.
• Citric acid may be purchased at a pharmacy, drug store
or super market.
Note
Depending on water quality and the usage environment,
water in the humidifying tray may become discoloured due
to water scales etc. Clean it also in such cases.
Attention
Silver ion cartridge
•
Do not remove.
•
Do not clean with citric acid or baking soda.
Loss of the capacity for slime-resistance will result.
Float
•
Do not remove.
Humidifying operation will become
impossible.
If the fl oat detaches from the tray
1 Place the fl oat protrusion
onto the tray protrusion
2 Insert the axle on the fl oat
protrusion side into the hole
of the tray
3 Insert the axle into the hole
of the tray
2
1
3
Protrusion on tray
Sectional view
Float
• Fill the tray with water and check
that the fl oat rises to the water
surface.
• After checking, be sure to discard
the water, then attach the
humidifi cation tray to the unit.
Removing the humidifying tray and
humidifying fi lter unit
1.
Take out the water tank from the main unit.
►
Page 12
2.
Remove the humidifying tray and then remove
the humidifying fi lter unit from the tray.
Humidifying tray
Humidifying fi lter unit
Lift up slightly and pull out
Hold the outer
periphery of
the frame
• Hold the base of the humidifying tray, lift up slightly
and pull out.
• Pull out the tray gently, because if there is any water
inside, the water surface may ripple and it may spill out.
• When carrying, hold the base of the humidifying tray.
Attaching the humidifying tray and
humidifying fi lter unit
1.
Attach the humidifying tray and humidifying
fi lter unit.
1
Attach the humidifying fi lter unit to the tray.
Fit axle into groove in
humidifying tray
Axle
Humidifying fi lter
• Attach the humidifying fi lter unit in the orientation
shown in the illustration.
If attached in the opposite orientation, it may become
impossible to remove the humidifying tray, the humidifi cation
performance may deteriorate, or abnormal noise may occur.
2
Fully push in the humidifying tray to the main unit.
Attention
After installing the humidifying tray to the main unit, do not forcibly
rotate the humidifying fi lter unit. Malfunction may result.
2.
Put the water tank in.
►
Page 12
