42
4.8.4
Register
This function allows the device to auto register to the proxy you specified. In this way, you can use
the client-end to access the DVR and etc via the proxy. Here the proxy has a switch function. In
the network service, device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the
auto register function, the device can auto register to the proxy server.
1) The setup interface is shown as in Figure 4-31.
Important
Do not input network default port such as TCP port number.
Figure 4-31
2) The proxy server software developed from the SDK. Please open the software and input the
global setup. Please make sure the auto connection port here is the same as the port you set in
the previous step.
3) Now you can add device. Please do not input default port number such as the TCP port in the
mapping port number. The device ID here shall be the same with the ID you input in Figure 4-31.
Click Add button to complete the setup.
4) Now you can boot up the proxy server. When you see the network status is Y, it means your
registration is OK. You can view the proxy server when the device is online.
Important
The server IP address can also be domain. But you need to register a domain name before you
run proxy device server.
4.8.5
Auto Maintenance
Here you can set auto-reboot time and auto-delete old files, auto shutdown, and auto ACC delay
(0-65535 minutes) setup. You can set to delete the files for the specified days. See Figure 4-32.
After all the setups please click save button, system goes back to the previous menu.
Note
The auto boot up and ACC delay function is only valid when vehicle ACC signal connection is OK.
The auto shut down has higher priority than ACC delay. If you enable these two functions at the
