xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
56
download
Parameters
firmware_fromTFTP
−
Download and install new firmware on the Switch from a TFTP
server.
•
<ipaddr>
−
The IP address of the TFTP server.
•
<ipv6addr> -
The IPv6 address of the TFTP server.
•
<path_filename 64>
−
The DOS path and filename of the firmware file on the
TFTP server. For example, C:\3612.had.
•
unit <unitid1-12>-
Enter the ID of the Switch in the switch stack to where to
save the file.
•
all
– Use this parameter to select all switches in the switch stack.
•
<drive_id>
- Enter the drive ID of the internal flash drive to where to save the
file.
•
{<pathname 64>} –
The
pathname
in the command refers to the flash memory
located on the switch. This drive is nominated c: and those who wish to save
the firmware, instead of uploading it directly to the NV-RAM must specify the
path on the flash memory to place this file (ex. c:/firm1). The filename cannot
exceed 64 alphanumeric characters.
•
boot_up –
Enter this parameter to use this file as the boot up file upon next
reboot of the switch.
config_fromTFTP
−
Download and install a configuration file on the Switch from a TFTP
server.
•
<ipaddr>
−
The IP address of the TFTP server.
•
<ipv6addr> -
The IPv6 address of the TFTP server.
•
<path_filename 64>
−
The DOS path and filename of the switch configuration
file on the TFTP server. For example, C:\3612.had.
•
<drive_id>
- Enter the drive ID of the internal flash drive to where to save the
file.
•
{<path_filename 64>} –
The second
path_filename
in the command refers to
the flash memory located on the switch. This drive is nominated c: and those
who wish to save the firmware, instead of uploading it directly to the NV-RAM
must specify the path on the flash memory to place this file (ex. c:/config1).
The filename cannot exceed 64 alphanumeric characters.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To download a configuration file:
DGS-3627:5#download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Command: download cfg _fromTFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DGS-3627:5#
DGS-3627:5##---------------------------------------------------------------------------------------------------------
DGS-3627:5## DGS-3627 Configuration
DGS-3627:5##
DGS-3627:5## Firmware: Build 2.40-B19
DGS-3627:5## Copyright(C) 2008 D-Link Corporation. All rights reserved.
DGS-3627:5##---------------------------------------------------------------------------------------------------------
DGS-3627:5#
DGS-3627:5#
DGS-3627:5## BASIC
DGS-3627:5#
DGS-3627:5#config serial_port baud_rate 115200 auto_logout 10_minutes
Command: config serial_port baud_rate 115200 auto_logout 10_minutes
