xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
208
config limited_multicast_addr
Description
This command will perform three tasks for the multicast range. It may
add switch ports to the range, delete ports from the multicast range and
it may also give these multicast addresses access to the switch, or
configure them to be restricted from accessing the Switch.
Parameters
ports <portlist> -
Used to add a list of ports to the multicast range. The
beginning and end of the port list range are separated by a dash. Non-
contiguous portlist entries are separated by a comma. (ex: 1-3,7-9)
add
– Use this parameter to add ports to the multicast range specified
by the following parameter.
•
multicast_range <range_name 32>
- Enter a name of up to 32
alphanumeric characters that will be used to identify this
multicast range to be configured.
delete
– Use this parameter to delete ports from the multicast range
specified by the following parameters.
•
multicast_range <range_name 32>
- Enter a name of up to 32
alphanumeric characters that will be used to identify this
multicast range to be configured.
•
all
– Use this parameter to delete these ports from all
multicast ranges.
access
– Use this parameter to grant or deny permission of the
multicast addresses for the ports based on the following parameters.
•
permit
– Use this parameter to grant permission to the switch
for this multicast range.
•
deny
– Use this parameter to deny access from the switch for
this multicast range.
state [enable | disable]
– Use these parameters to enable or disable
this multicast configuration.
Restrictions Only
administrator-level
and operator-level users can issue this
command.
Example usage:
To add ports to the multicast range:
DGS-3627:5#config limited_multicast_addr ports 5-8 add multicast_range
accounting
Command: config limited_multicast_addr ports 5-8 add multicast_range accounting
Success.
DGS-3627:5#
Example usage:
To grant the multicast range permission to access the ports:
DGS-3627:5#config limited_multicast_addr ports 5-8 access permit
Command: config limited_multicast_addr ports 5-8 add access permit
Success.
DGS-3627:5#
