CYP CDPS-CS4, Руководство по эксплуатации, Страница: 8 / 28

3
sending an IR signal. The LED will also illuminate when learning IR
commands.
6 COMMS LED: This LED will blink when the COM ports are sending/
receiving data. It will also blink when macros are executed (1 flash
for each command within the macro).
6.2 Rear Panel
IRL
RESET
DC 5V
1 2 3 4 5 6 7 8
GND
IN
1 2 3 4 5 6 7 8
RELAY OUT
USB
LAN
1 2 3 4 COM 1 COM 2 INFRARED OUT
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8 9
1 IRL: Connect to the IR Learning Receiver included in the package.
This is used to capture the IR signal broadcast by your remote
when you press a button for retransmission as a part of a macro.
The IR data will be captured and stored in a text format within the
WebGUI. For IR Learning instructions please refer to section 6.8.3.
2
IR OUT 1~8: Connect to the provided IR Blasters to transmit IR
signals to devices within direct line-of-sight of the IR Blaster.
3 TRIGGER IN 1~8: Connect to any device with trigger or switch
functionality such as window security alarms, motion detectors,
door switches, etc. Each of the 8 trigger inputs will activate the
associated macro when triggered.
The upper row of contacts should be connected to the positive
pins of your sources and the lower row of contacts should be
connected to the negative pins. If the polarity is incorrectly aligned
then the trigger won’t activate. A minimum of 5V DC is required to
activate the trigger.
4 RELAY OUT 1~8: Connect to devices that support DC 0~24V/5A
relay trigger functionality to power or activate them via macro
commands.
5
COM 1~2: Connect to RS-232 controllable devices to send
commands to those devices via macros. It is also possible to send
commands directly to your RS-232 connected devices via the
Ethernet connection.
To do this, connect to the Control System using a Telnet client via
port 7501 (to send to COM 1) or port 7502 (to send to COM 2).