CYBEX 530C, Руководство пользователя

Страница: 51 / 88

Cybex 530C and 530R Owner’s Manual
There are two drive belts that may become worn or cracked. See Figure 2.
Primary Belt - This is the wider of the two belts.
It has ten ribs that keep it aligned on the large
drive pulley.
Secondary Belt - This is the narrower of the two
belts. It has six ribs that keep it aligned on the
secondary pulleys.
Follow this Drive Belt Maintenance procedure to
ensure that the belts are aligned properly and
in good condition.
NOTE: If a belt has cracks or
appears worn, it must be replaced immediately by
a qualified service technician.
Tools Required
• 6 mm, Allen wrench
• Phillips head screwdriver
! WARNING: Disconnect the optional power
adapter before beginning this
procedure. Keep wet items away
from inside parts of the unit. Do
not touch components on the
lower board. A charge can remain
even if the unit is unplugged.
1. Read and understand this Drive Belt
Maintenance section thoroughly before
proceeding to step 2.
2. Disconnect the optional external power
source.
A. If your unit is has an optional power
adapter, Unplug the power adapter from
the power outlet.
Cybex 530C Cycle
3. Remove the crank arms.
A. Using a 6 mm Allen wrench, remove the
two screws and washer securing each of
the crank arms. See Figure 3.
B . Remove the crank arms. NOTE: The cycle
is equipped with a left and a right crank
arm. The right crank arm has a pin that
inserts into a hole in the drive sprocket.
Primary
Drive Belt
(10 ribs)
Figure 2
Secondary
Drive Belt
(6 ribs)
Figure 3
Crank Arm
Washer
Screws (2)
Drive
Sprocket
Hole
Pin
Preventive
Maintenance
Page 4-3
Drive Belt Maintenance