CyberOptics AMS-150C, Руководство пользователя

Страница: 31 / 143

31
Changing the Pairing between the AMS and Link
The AMS and link module in your kit were paired at the factory and will operate with only that particular link
module. You can change this pairing, so that you can use your AMS with a different AMS link module, or vice versa.
Link modules for different CyberOptics WaferSense or ReticleSense products, such as Auto Gapping Sensors (AGS),
are not interchangeable.
To pair an AMS and link module:
1)
If you are changing the pairing of an AMS that is already paired with a link module, first unplug the currently
paired li
nk module. You can’t pair an A MS with a new link module, while the currently paired link module is
powered on.
2)
Make sure the Power LED is illuminated on the link module you want to pair, and make sure the Unit on LED is
illuminated on the AMS.
3)
On the AMS , press and hold the “C” reset switch until the Connect/Pair LED starts to blink rapidly (about four
times per second).
4)
On the link module, press and hold the New Pair button until the Pair Status and Connection Status LED lights
start to blink rapidly (about four times per second).
The LEDs on the link module and the AMS will continue to blink for a few seconds, until the link and the AMS
have established a new pairing, after which the LEDs will be on and no longer blinking.