CyberOptics AMS-150C, Руководство пользователя

Страница: 15 / 143

15
Checking the Communications Between the Link
and the AMS
To complete the installation, verify that the AMS and link can communicate:
1)
The AMS operates from an internal rechargeable battery. Before using the AMS for the first time, charge it for
two hours. For information on checking the charge on the battery and the procedure for recharging, see
“ Using the Rechargeable Battery ” on page 28 .
2)
On the AMS, there are reset switches as described in the “ Introduction ” section on page 9 . These switches are
recessed and are rarely used, and require the use of a paper clip, or small device to activate. Placing the unit in
the charging case and connecting the charger power supply will start the AMS, see
“ Opening and Closing the
Charging Case ” on page 22 .
3)
Verify that the Pair Status lights on both the AMS and link module are on. The AMS and link module in your kit
were paired at the factory and will operate with only that particular link module. If either light is not on, your
AMS and link might not be paired with each other. To reset the pairing, see
“ Changing the Pairing between the
AMS and Link ” on page 31 .
4)
Immediately after turning on the AMS, the Connection Status lights on the AMS and link will blink slowly.
After a few seconds the AMS and link will connect and both lights will be on and no longer blinking. If the
lights continue to blink, see
“ Monitoring the Wireless Connection to the AMS Device ” on page 30 .
5)
After starting the MultiView application (see “ Running the MultiView Application ” on page 17 ), you can verify
the connection to the AMS by comparing the serial number printed on the AMS to the serial number shown in
the
About dialog, which is available in the MultiView application by choosing the Help > About menu item. If
the MultiView application is not running, the AMS turns off automatically after 30 minutes.
That completes the installation of your AMS system.