Custom Audio Electronics KPM150H, Руководство пользователя

Страница: 85 / 96

10.4 Printing area
It is important to well calibrate the height of the printing area of ticket according to the inter-notch distance, in order
to print ticket containing only one notch and to not overlay printing to a notch (that will make it useless for the next
alignment).
The following fi gure shows an example of tickets with “Notch Distance” set to 0:
PRINTING
AREA
Printing line
Cutting line
A D H A
L
direction of
paper feed
To use all the notches on the card, you must comply with the following equation:
L > H + A
where
L = INTER-NOTCH DISTANCE
A = NON-PRINTABLE AREA ( 0mm ≤ A ≤ 26.5mm )
H = HEIGHT OF THE PRINTING AREA
The height of the printing area (H) can be increased to make no progress on alignment (D = 0) but no further.
In CUSTOM/POS emulation, after a performed cut, the paper is not completely recovered (in orde to avoid jamming
when using of thin paper). This decreases the height of the non-printable area : A = 10mm.
So, in this emulation, it is important to consider the presence of this non-printable area when you de
fi ne the layout
of the ticket to print. Otherwise, you can use the command $1C $C1 to recover paper completely (see Commands
Manual for more details).
The SVELTA emulation, instead, it is designed speci fi cally for ticketing and then for using with heavy paper, which
avoids the risk of paper jams. After performing a cut, the device completely recovers the paper and therefore the
distance of recovery after cutting does not generate non-printable areas: A = 0.
10. ALIGNMENT
User manual
KPM150H 85