Custom Audio Electronics KPM150H, Руководство пользователя

Страница: 76 / 96

10.1 Enable alignment
Printer is provided with 2 alignment sensors, placed as follows:
•
1 mobile sensor on the lower fl at of printer
• 1 sensor on the upper fl at of printer.
To guarantee the alignment, it is necessary to correctly choose the sensor to use for the notch detection depending
on the type of notch and its location on the ticket.
To do this, you must enable the parameter “Notch/B.Mark Position” during the Setup procedure (see cap.5) and set
the correct value of this parameter as described in the following table.
SENSOR
USED
(see following
fi gure)
VALUE OF THE
“NOTCH/B.MARK POSITION”
PARAMETER
USING MODE
OF SENSORS
NOTCH TYPE
NOTCH POSITION ON
TICKET
- Disabled - Alignment disabled N.A.
1 Bottom Re fl ection Black mark printed on paper Non-thermal side
2 Top Re fl ection Black mark printed on paper Lateral thermal side
1 + 2 Transparent Transparence
Hole between tickets or
gap between labels
Lateral
lower flat
upper flat
direction
of paper
feed
1 1
2 2
The following fi gures show the usable format of paper and the corresponding sensors used for alignment:
10. ALIGNMENT
76 KPM150H
User manual